TP-LINK TD-W8968 V4 Betriebsanweisung PDF herunterladen (Seite 32)

TD-W8968 300Mbps Wireless N USB ADSL2+ Modem Router User Guide

 Authentication Method: Select the Authentication Method from the drop-down list, the

default method is AUTO, and you can leave it as a default setting.



Note:

If you are not sure about the PPP IP extension and PPP Debug Mode etc. below, please don’t

select these options.

 MTU Size: Maximum Transmission Unit Size. Check this box then you can change the MTU

size. The default MTU value is 1480 Bytes. It is not recommended that you change the default

value unless required by your ISP.

 Enable NAT: This technology translates the IP addresses of a local area network to a different

IP address for the Internet. If this modem router is hosting your network’s connection to the

Internet, please select the check box. If another router exists in your network, you don’t need to

select the option.

 Enable Fullcone NAT: It is a type of NAT, if not enabled, the default NAT will act.

 Dial on demand (with idle timeout timer): The modem router will cut off the Internet

connection after it has been inactive for a specific period of time (idle timeout), and it will

automatically re-establish the connection as soon as you attempt to access the Internet again.

If your Internet is charged by time you may want to select this option in order to save money.

 PPP IP extension: Select this option to get the public IP address from the PPP server to your

PC, and the NAT and SPI Firewall will be closed. Sometimes you can think it as bridge while

PPP dialing in the modem router. It’s a special feature deployed by some ISP. Unless your ISP

specifically requires this setup, do not select it.

 Use Static IPv4 Address: If your ISP gives you a static WAN, Gateway and DNS IP address,

select this option to enter them manually.

 Enable PPP Debug Mode: Select this option to debug the PPP function and you can see

many PPP log information in the System Log. Only PPP has this debug Mode.

 Bridge PPPoE Frames Between WAN and Local Ports: Select this option to start PPP

connection in your local PC.

 Enable IGMP Multicast Proxy: IGMP (Internet Group Management Protocol) is used to

manage multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote

configuration for client devices, such as the router. The default value is disabled, and if you are

5. Select a preferred wan interface as the system default gateway in Figure 4-11 and click Next.

Figure 4-11

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 116 117

Keine Kommentare

TP-LINK TD-W8968 V4 Betriebsanweisung Seite 32