TP-LINK TD-W8961ND V1 Installationsanleitung PDF herunterladen (Seite 2)

Plug the provided Power

Adapter into the Power jack

on the back of the Router and

the other end to a standard

electrical wall socket.

Power on all your network devices and then check to see if the LEDs of the

Router display normally as the diagram below describes.

If the LEDs display abnormally, please check to see if all the cable

connectors (power adapter, phone line and Ethernet cable) are well

connected to your device. With the phone line well connected, if the

ADSL LED turns off after flashing, please contact your ISP to ensure that

your internet connection is active.

Note

WLAN: Solid light or flashing

ADSL: Solid light or flashing

Power: Solid light

LAN: Solid light if the corresponding

ort is connected

To configure the device, you can either run the setup CD-ROM (method one),

or run the Web based Quick Setup Wizard (method two). TP-LINK strongly

recommends that you run the setup CD-ROM.

Note

If the LEDs display abnormally, please check to see if all the cable

connectors (power adapter, phone line and Ethernet cable) are well

connected to your device. With the phone line well connected, if the

ADSL LED turns off after flashing, please contact your ISP to ensure that

your internet connection is active.

1 2 3 4 5 6 7 ... 17 18

Keine Kommentare

TP-LINK TD-W8961ND V1 Installationsanleitung Seite 2