TP-LINK TD-8816 Bedienungsanleitung Seite 1

TD-8816 ADSL2/2+ Ethernet Router Rev：1.0.0

TD-8816 ADSL2/2+ Ethernet Router User Guide 4¾ LAN: Through the port, you can connect the Router to your PC or the other Ethernet network devices.

TD-8816 ADSL2/2+ Ethernet Router User Guide 5 Figure 2-3

TD-8816 ADSL2/2+ Ethernet Router User Guide 6 Chapter 3. Quick Installation Guide 3.1 Configure PC After you directly connect your PC to the TD-8

TD-8816 ADSL2/2+ Ethernet Router User Guide 7 Figure 3-2 Step 3: Select General tab, highlight Internet Protocol (TCP/IP), and then click the Prope

TD-8816 ADSL2/2+ Ethernet Router User Guide 8Step 4: Configure the IP address as Figure 3-4 shows. After that, click OK. Figure 3-4 ) Note: You ca

TD-8816 ADSL2/2+ Ethernet Router User Guide 9If the result displayed is similar to the screen shown below, it means that your PC has not connected t

TD-8816 ADSL2/2+ Ethernet Router User Guide 10Step 1: Select the Quick Start tab, then click RUN WIZARD, and you will see the next screen. Click th

TD-8816 ADSL2/2+ Ethernet Router User Guide 11 Figure 3-11 Step 5: Configure the following options provided by your ISP: Username, Password, VPI, V

TD-8816 ADSL2/2+ Ethernet Router User Guide 12 Step 6: Click NEXT to finish the Quick Start. Figure 3-13

TD-8816 ADSL2/2+ Ethernet Router User Guide 13 Chapter 4. Software Configuration This User Guide recommends using the “Quick Installation Guide” f

COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other

TD-8816 ADSL2/2+ Ethernet Router User Guide 14 Figure 4-2 ) Note: Click the other submenus System Log or Statistics in Figure 4-2, you will be able

TD-8816 ADSL2/2+ Ethernet Router User Guide 154.3.1 Internet Choose “Interface Setup→Internet” menu, you can configure the parameters for WAN ports

TD-8816 ADSL2/2+ Ethernet Router User Guide 16• Virtual Circuit: Select the VC number you want to setup, PVC0~PVC7. • Status: If you want to use a

TD-8816 ADSL2/2+ Ethernet Router User Guide 17for WAN interface, including RIP1, RIP2-B and RIP2-M. RIP2-B and RIP2-M are both sent in RIP-2 format,

TD-8816 ADSL2/2+ Ethernet Router User Guide 18 Figure 4-7 ¾ Username: Enter your username for your PPPoE/PPPoA connection. ¾ Password: Enter your

TD-8816 ADSL2/2+ Ethernet Router User Guide 19If you select this type of connection, the modem can be configured to act as a bridging device between

TD-8816 ADSL2/2+ Ethernet Router User Guide 20Internet. • IP Address: Enter the Router’s local IP Address, then you can access to the Web-based Uti

TD-8816 ADSL2/2+ Ethernet Router User Guide 21• Lease Time: The length of time for the IP lease. After the dynamic IP address has expired, the user

TD-8816 ADSL2/2+ Ethernet Router User Guide 22 4.4 Advanced Setup Choose “Advanced Setup”, you can see the next submenus: Figure 4-12 Click any of

TD-8816 ADSL2/2+ Ethernet Router User Guide 23 Figure 4-14 Click ADD ROUTE button to add a new route in the next screen (shown in Figure 4-15). Fig

FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules

TD-8816 ADSL2/2+ Ethernet Router User Guide 24 Figure 4-16 ¾ Virtual Circuit: Enter Virtual Circuit Index that you plan to setup for the NAT functi

TD-8816 ADSL2/2+ Ethernet Router User Guide 25The Virtual Server is the server or server(s) behind NAT (on the LAN), for example, Web server or FTP

TD-8816 ADSL2/2+ Ethernet Router User Guide 264.4.3.3. IP Address Mapping Choose “Advanced Setup→NAT→IP Address Mapping” in Figure 4-16, you can co

TD-8816 ADSL2/2+ Ethernet Router User Guide 27Click the Back button to return to the previous screen. Click the CANCEL button to cancel the configur

TD-8816 ADSL2/2+ Ethernet Router User Guide 28DiffServ). ¾ Summary: Click the button to view the configurations of QoS. ¾ Rule: Configure the rule

TD-8816 ADSL2/2+ Ethernet Router User Guide 29can communicate as if they were attached to the same wire, when in fact they are located on a number o

TD-8816 ADSL2/2+ Ethernet Router User Guide 302. Define VLAN Group Click Define VLAN Group in Figure 4-21, you can define VLAN groups in the next

TD-8816 ADSL2/2+ Ethernet Router User Guide 31 Figure 4-24 ¾ ADSL Mode: Select the ADSL operation mode which your ADSL connection uses. ¾ ADSL Typ

TD-8816 ADSL2/2+ Ethernet Router User Guide 32 Figure 4-26 ¾ ACL: If Activated, the IP addresses which are contained in the Access Control List c

TD-8816 ADSL2/2+ Ethernet Router User Guide 33 Figure 4-27 ¾ Filter Type Selection: Select the filter type for the next configuration. ¾ IP/MAC Fi

Package contents The following contents should be found in your box: ¾ One TD-8816 ADSL2/2+ Ethernet Router ¾ One AC power Adapter for TD-8816 A

TD-8816 ADSL2/2+ Ethernet Router User Guide 34allowed by setting up filters. ¾ IP/MAC Filter Rule Index: Select the Rule index for the IP Filter en

TD-8816 ADSL2/2+ Ethernet Router User Guide 35) Note: If you want to make the rule take effect, please select Yes to active the rule. Step 3: Enter

TD-8816 ADSL2/2+ Ethernet Router User Guide 36 Figure 4-28 ¾ Rule Type: Select MAC for the MAC Filter rule. ¾ Active: Select “Yes” to make the rul

TD-8816 ADSL2/2+ Ethernet Router User Guide 37select the Interface “PVC0”, and select the Direction “Outgoing” for the first rule. ) Note: If you w

TD-8816 ADSL2/2+ Ethernet Router User Guide 38 Figure 4-29 ¾ Filter Type Selection: Select the Application Filter for the next configuration. ¾ Ap

TD-8816 ADSL2/2+ Ethernet Router User Guide 39To add a URL filter entry: For example: If you want to forbid the user to access the website: www.sina

TD-8816 ADSL2/2+ Ethernet Router User Guide 40 Figure 4-32 ¾ UPnP: Activate or Deactivate the UPnP function. Only when the function is activated, c

TD-8816 ADSL2/2+ Ethernet Router User Guide 41¾ Wildcard support: Select the option to use Wildcard function 4.5.6 CWMP Choose “Access Management→

TD-8816 ADSL2/2+ Ethernet Router User Guide 42 Figure 4-35 Click any of them, and you will be able to configure the corresponding function. 4.6.1 A

TD-8816 ADSL2/2+ Ethernet Router User Guide 43 Figure 4-37 ) Note: The ADSL Router built-in some NTP Servers, when the Router connects to the Intern

COMMENT Chapter 1. Introduction ... 1 1.1 Product Overview...

TD-8816 ADSL2/2+ Ethernet Router User Guide 44 Figure 4-39 4.6.3 Firmware Choose “Maintenance→Firmware”, you can upgrade the firmware of the Router

TD-8816 ADSL2/2+ Ethernet Router User Guide 45the router is not experiencing difficulties, there is no need to download a more recent firmware versi

TD-8816 ADSL2/2+ Ethernet Router User Guide 46Step 1: Click the Browse button to locate the update file for the device, or enter the exact path in

TD-8816 ADSL2/2+ Ethernet Router User Guide 47 Figure 4-45 ) Note: Click the tab, and you will be able to get the corresponding information.

TD-8816 ADSL2/2+ Ethernet Router User Guide 48 Appendix A: Specification General Standards and Protocols ANSI T1.413, ITU G.992.1, ITU G.992.2, ITU

4.6.4 System Restart...46 4.6.5 Diagno

TD-8816 ADSL2/2+ Ethernet Router User Guide 1 Chapter 1. Introduction 1.1 Product Overview Thank you for choosing the TD-8816 ADSL2/2+ Ethernet R

TD-8816 ADSL2/2+ Ethernet Router User Guide 2¾ Supports Multiple PVC (Permanent Virtual Circuit). ¾ Built-in DHCP server. ¾ Built-in firewall, su

TD-8816 ADSL2/2+ Ethernet Router User Guide 3 Chapter 2. Hardware Installation 2.1 The Front Panel Figure 2-1 The LEDs locates on the front pane